This article describes how issues related to the RTP Packetization interval can be solved in the case of conference calls on VoipNow servers. The recommended solution is to make sure that all parties involved in that call have the packetization interval set to 20ms during conference calls on VoipNow servers. Otherwise, when channels are bridged, voice breaks, missing or dropped syllables, unexplained clicks or noises may occur.
Voice breaks, missing or dropped syllables, unexplained clicks or noises are triggered by different values of the ptime
parameter when channels are bridged. According to the RFC3551 for packetized audio, the default packetization interval must be 20 ms or one frame, whichever is longer, unless required otherwise. However, a receiver should be able to accept packages with a packetization interval between 0 and 200ms.
If autoframing=yes
is set in sip.conf
within the global section, all calls will try to set the packetization based on the preferences of the remote end point.
When autoframing is enabled at global level, it applies to all regardless of the selected codec packetization.
If one of the parties involved in a call does not provide a ptime
interval, the recommended value that should be used is 20ms.
In VoipNow, autoframing is not enabled in |
The ptime
parameter for codecs can be set through provisioning by adding a specific value for each codec in the Device Configuration File #3
:
voice.audioProfile.X.payloadSize="20" |
The value for the payload size is in milliseconds: 10, 20, 30,...80;
X can be replaced by G711Mu, G711A, G722, G7221, and G729AB. |
For example, when setting a ptime=20
for the G711A codec, the following line should be added to the provisioning template:
voice.audioProfile.G711A.payloadSize="20" |
Aastra 480i
ptime
parameter on a Aastra 480i codec, you need to go to the Advanced Settings->Global SIP->RTP Settings area;For example:
payload=8;ptime=20; payload=0;ptime=20; |
Please note that |
Web Interface
Go to Advanced Settings -> iLBC frame size and select a framesize of 30ms.
Provisioning Template
You need to set the P97
variable to 1 as shown below:
# iLBC Frame Size. 0 - 20ms(default), 1 - 30ms. P97 = 1 |
The ptime
parameter can be set via provisioning templates.
In the device configuration file 1, you can set the ptime value as shown below:
[ account ] path=/config/voip/sipAccount0.cfg <yealink t20p configuration parameters> ptime = 20 [ account ] path=/config/voip/sipAccount1.cfg <yealink t20p configuration parameters> ptime = 20 |
Some Linksys devices, such as PAP2 or SPA2102, have the RTP Packet Size
parameter set to 30ms by default.
In such cases, the RTP Packet Size
parameter can be changed from the SIP tab of the web interface.
For most users, the 0.030 factory default preset should be replaced with 0.020.
Please note that the |
To set the RTP packetization
interval on Siemens Speedstream 3610, you need to go to the Voice Setup -> Advanced Setting.
If you are using this device registered on a VoipNow server, please set the RTP Packetization period to 20ms. Valid values: in increments of 10ms.